Hello all,
I went looking on the net for printable targets for sghting in and practicing smallbore at 50m.
I wanted something with 6 targets, and not too busy on an A4 sheet. Couldn't find what I was after, and then realised I could probably make my own with the draw function on MS Word.
So I did. It wasn't that hard to put a 1" circle in a 2" square, and then give it a few reference points. And if you have your "page setup" set to A4 paper, it prints to size, so it's all good.
And then I figured I should share.
I hope the attachments work.......haven't done it before, but hopefully I got it right.
regards, curan
Printable targets
- Knackers
- .338 Lapua Magnum
- Posts: 2381
- Joined: Sun Aug 06, 2006 9:22 pm
- Favourite Cartridge: .223
- Location: Riverina NSW
Re: Printable targets
Thanks for sharing Curan, they will come in handy.
- steven
- .222 Remington
- Posts: 399
- Joined: Wed Jul 12, 2006 5:57 pm
- Favourite Cartridge: 6ppc
- Location: Tamworth
Re: Printable targets
Try this one,it fits on A4
Steve
Steve
- Attachments
-
- TargetC.pdf
- (61.97 KiB) Downloaded 51 times
-
- .222 Remington
- Posts: 364
- Joined: Tue Aug 08, 2006 3:55 pm
- Location: Mansfield
Re: Printable targets
Hey Guys here is one that i 'stole' from a fellow member.
Using Excel you can add load data etc on the targets.
Using Excel you can add load data etc on the targets.
- Attachments
-
- Target - MOA.xls
- (48 KiB) Downloaded 60 times