Made this up over the last few days out of a few bits and pieces of timber that I have in the shed. Red gum lid, pine base, oak sides and ends, silky oil and red cedar for other bits like spare shaft holder, darts holder and spare flight pocket
Thanks, yeah pretty chuffed, though there are a few errors, couple of gaps and such, 2mm narrower at one end, but it turned out ok. Was a good practice run, will probably do another but take a bit more care.
Knife handles done over the last week or so in between waiting for glue to dry, all old resurrected knives I have picked up over the years. Some Greenrivers, an F Dick or two, and some hand forged, some I don’t know, but they all have good high carbon steel in them, and I will use them when doing sheep killing and butchering, three on the end are still to do
Camel wrote: ↑Tue Jul 16, 2019 12:21 pm
Knife handles done over the last week or so in between waiting for glue to dry, all old resurrected knives I have picked up over the years. Some Greenrivers, an F Dick or two, and some hand forged, some I don’t know, but they all have good high carbon steel in them, and I will use them when doing sheep killing and butchering, three on the end are still to do