It’s a start.....

[Camel]

Went shopping for some material for my next project





Will gets some dirt on my hands tomorrow and should get most of it done

[trevort]

hope you remembered the pulleys

[Camel]

Only need one and I have it in the shed amongst my other bits and pieces.

[trevort]

Looking forward to seeing this


Sent from my iPhone using Tapatalk

[barryb]

me too ! just love seeing geniuses at work

[Camel]

me too ! just love seeing geniuses at work

Trev is the brains behind this little job, me, I am just the Rufasfuk putter togetherer.

[Rabbitz]

me too ! just love seeing geniuses at work

Ahhh.

A usage of the word Genius, of which I was not previously aware.

By the by, I assume this is a bullbar dead critter picker upper (aka BDCPU)?

[Camel]

me too ! just love seeing geniuses at work

Ahhh.

A usage of the word Genius, of which I was not previously aware.

By the by, I assume this is a bullbar dead critter picker upper (aka BDCPU)?

Yep, well sorta

[Camel]

Bit of progress to report

[kickinback]

Bit of progress to report

No elec winch?

A diesel stalker you are not.


Sent from my iPhone using Tapatalk Pro

[Camel]

Trev is too much of a tight arse for that



Got the feet and ground pins done

[Camel]

The top bit that holds it all together and provides a hanging point



Well.... hopefully

[trevort]

You are not just the putter togetherer, you are the Chief Engineer of RAF Productions too.

Looking good

[Rabbitz]

Just did an ASIC search Rufasfuk is not currently a business name.



Also RAF productions is available, without the need to explain fuk...

[Camel]

Gee you are a great help, thanks Rabz

First top design allowed too much wobble, hit the drawing board again and came up with V2,



Much betterer and bugger all wobble, just need to finish the pins then onto fitting lower leg sections, then a cap with hook to go over the top