Don't try this at home folks

[dashooter]

Looks like AR2225 is the powder for speed.
86.0 grains behind 123 SST!
Might back it off a couple of grains though. Was a bit sticky on bolt lift.
Didn't test accuracy after I found bolt lift was sticky.



Sent from my iPhone using Tapatalk

[mick_762]

1 shot. . Where's your dedication to accuracy of data?

[Seddo]

1 shot. . Where's your dedication to accuracy of data?

I always delete the first shot

[bimbo]

1 shot. . Where's your dedication to accuracy of data?

Probably more dedicated to conserving barrel longevity

[mick_762]

1 shot. . Where's your dedication to accuracy of data?

Probably more dedicated to conserving barrel longevity

Barrels are consumables, just like powder and projectiles.

[dashooter]

Bolt lift was a bit too sticky for my liking. Had 3 more to test accuracy but didn't want to push it. Also had 4 more loaded with 87.0 grains of 2225 that didn't get a run.

[dashooter]

1 shot. . Where's your dedication to accuracy of data?

[dashooter]

1 shot. . Where's your dedication to accuracy of data?

Probably more dedicated to conserving barrel longevity

Barrels are consumables, just like powder and projectiles.

Not worried about barrel so much as blowing extracters etc.

[mick_762]

Bolt lift was a bit too sticky for my liking. Had 3 more to test accuracy but didn't want to push it. Also had 4 more loaded with 87.0 grains of 2225 that didn't get a run.

So what were the numbers you were "aiming for" - no. . . Well actually yes, pun intended.

From your thoughts to actual velocity.

[mick_762]

1 shot. . Where's your dedication to accuracy of data?

Probably more dedicated to conserving barrel longevity

Barrels are consumables, just like powder and projectiles.

Not worried about barrel so much as blowing extracters etc.

Fair call too!!

[dashooter]

Bolt lift was a bit too sticky for my liking. Had 3 more to test accuracy but didn't want to push it. Also had 4 more loaded with 87.0 grains of 2225 that didn't get a run.

So what were the numbers you were "aiming for" - no. . . Well actually yes, pun intended.

From your thoughts to actual velocity.

Quickload estimated it around 3540 fps so it's a bit out. Interestingly Quickload also predicted similar velocity with 2218 (90.0 grains) but realized velocity was only 3300 fps. Certainly it's a lot faster than expected.

[MISSED]

Way Kool

[macca]

Flat and hard hitting even at a slightly slower pace. Will do everything you expect. Very way kool.
Cheers

[stinkitup]

Those sst's or some nosler 120bts should be fun at 3600+ very fun