Homemade Annealing Machine

[stinkitup]

Cheers Adam again. Think I will pick up some bits amd pieces should make forming cases a little nicer.

[WhiteMeat]

Bloody brilliant ! No auto feed was the downfall of all the prototypes on YouTube . So the question is how much are you gunna build them for ? Ausvarmint discount?

The intention is to have an aluminium backing plate and the machined bits available as a kit.

You buy the motor and PWM I linked earlier and it will bolt straight in. Some speaker wire, a little soldering, a 12v plugpack and your gas torch will see you sorted.

Not sure what is going to happen with the Fat Daddios tins, probably easiest to supply them as part of the kit and you just need to slot them (already drilled for holes and parted off at 32mm deep).

I'll get back to you. Wait out.

Also interested re the pricing on these kits ! Will make annealing a darn sight more lazy than doing the whole cordless screwdriver & deep socket gig...

[GregT]

I did some more playing around with this last week:

http://www.youtube.com/watch?v=dONsoESSdNc

Edit- how do I get a youtube video embedded?

[Camel]

Wow, GregT you are a bloody genius, I would even buy one of those, just to watch it go round and round. Well done mate.

[macca]

Simply put,i want one.
Really great work fellas.
I think you are on a winner.
Cheers

[adamjp]

I did some more playing around with this last week:

http://www.youtube.com/watch?v=dONsoESSdNc

Edit- how do I get a youtube video embedded?

It is under the other embed buttons.
http://www.youtube.com/watch?v=dONsoESSdNc

[Teepee]

Well done boys
Just goes to show what an enterprising mind or two can do.

[MISSED]

You blokes owe me 20 minutes

I just sat there and watched the video over and over again

[bimbo]

You blokes owe me 20 minutes

I just sat there and watched the video over and over again

It's hypnotic hey

[big G]

You blokes owe me 20 minutes

I just sat there and watched the video over and over again

It's hypnotic hey

Shithot.
Clevadicks.
I've watch it three times already.
Gotta watch it again .
Neat ,really neat.
Big G

[WhiteMeat]

Simply put,i want one.
Really great work fellas.
I think you are on a winner.
Cheers

Could not have said it better !

[223 fanboy]

That is a nice mechanism guys. Good on you for sharing it with us.

[Plowboy]

Very nice little gadget there! I have never looked at annealing, only doing .223s and neck sizing. Does it make much difference to sizing?

[B4408]

Great little modification, the best of two designs combined.
Do you need to use different width tins for long and short cases?

I went with a more conventional style as it suited the bits and pieces I had lying around. Yours has some advantages.

IMG_2119a.jpg (68.04 KiB) Viewed 903 times

Bruce

[stinkitup]

Nice bruce! I ordered some gear for one today so will see how I go, won't be as shit hot as Adams but hoping it does the job as will be for smaller batches of brass.

Ryan