Thinking of getting a .204rug?

Talk about your Varmint Rifles and other firearms here!
User avatar
wifecallsmegrumpy
.223 Remington
Posts: 404
Joined: Thu Nov 23, 2006 12:57 pm

Re: Thinking of getting a .204rug?

Post by wifecallsmegrumpy »

ryan, what's the control round feeing like with the small 204 case ? had any failure to feed or extraction issues ?

How many go in the Mag ?
Ryan

Re: Thinking of getting a .204rug?

Post by Ryan »

wifecallsmegrumpy wrote:ryan, what's the control round feeing like with the small 204 case ? had any failure to feed or extraction issues ?

How many go in the Mag ?

From memory... I dont think I had any problems cept chasing my brass if i pulled back on the bolt too fast. The first 9 or so shots were just one round and clean so i dont think i had any feeding problems the next nine was stress relief so I just loaded the mag full and shot. Tho I have only fired bout 19 rounds so far so may be too early to say. I assume it would be like my ruger .223 but the bolt is a bit smoother tho and the trigger a bit lighter. With the .223 ive only had problems with steel cases primarily WOLF shit.

I believe the mag held 5 rounds. The first round of a full mag may have been stiffer to strip but still loaded perfectly.
User avatar
trevort
Spud Gun
Posts: 12710
Joined: Thu Sep 14, 2006 9:21 pm
Favourite Cartridge: Tater
Location: Melbourne

Re: Thinking of getting a .204rug?

Post by trevort »

once you find what ammo it likes, buy 100 then keep your brass. Reloading with a few different brands of cases is a PITA. Call me when your ready.

Or you could go out buy 100 rem cases, a tub of 2206h rem 7 1/2 BR pimers 39gn SBKs and start the whole thing properly!!!
Ryan

Re: Thinking of getting a .204rug? (some results at last!)

Post by Ryan »

Finally got to the range today. Got the new scope zeroed. first group i shot was my best. Using factory Federal 39gn Sierra BK at 100 yrds.
It shows real promise for when i can start hand loading I hope to shrink the group by half at least. :wink:
Had one feeding problem with one round of 60 or so shot today, the tip flicked up and hit the receiver when I was pushing the bolt forward and damaged the plastic tip a little. I b elieve it was cause i must not have slide the round to the back of the mag when I loaded it. Also found that it doesnt like to be loaded by just dropping a round into the ejection slot and closing the bolt, it will chamber but wont lock or grab the cartridge rim. It only chambers correctly when a round is fed from the mag.

Now I just cant wait to get out to a forest to baptise it and try some instant rabbit disections (instantaneous paddock pizzafication) :mrgreen:

I think I love .204
Attachments
.204rug 39gn Sierra BK Fed factory, first group.
.204rug 39gn Sierra BK Fed factory, first group.
Post Reply