AusVarmint

Well it looks like the daisy Picking will be the unvailing of the 20/222 and 20 PPC

I have some 222 Sako and 223 Lap cases ready to go once I get the rifle in my hot little hands.

For the 20 PPC I just hope it likes my load for the other barrel but time will tell.

This would have to be the longest build that I have seen, just how many years ago did you form that 20/222 that you carried in your pocket for, what was it, 3 or 4 years ? I can't remember now.

On another note, I may, just may, have the new stock for my 22/250AI in my hot little hands later on this week, and may, just may, have it finished enough to bring down for a trial run. Thanks Geoff, remember you other fellas, Just Ask Geoff.

Camel wrote:This would have to be the longest build that I have seen, just how many years ago did you form that 20/222 that you carried in your pocket for, what was it, 3 or 4 years ? I can't remember now.

On another note, I may, just may, have the new stock for my 22/250AI in my hot little hands later on this week, and may, just may, have it finished enough to bring down for a trial run. Thanks Geoff, remember you other fellas, Just Ask Geoff.

Who’s the poor bastard you’ve conned into delivering that?


Sent from my iPhone using Tapatalk Pro

Truck with red back ground and a big white P in it.

Say Andy-roo, I bet you are going to use the 223 brass for form your cases so you can get more pressure, eh ?

That`s the Plan Humpy

And yes I still have that case I made 8 or 9 years ago

Guess what it was made up on a 223 case as well

So all went well mr missed with the reamer

UM well not exactly Sir Jack I met up with Russel at the Canberra Gun club on Saturday handed over the rifles and then remembered I had left the reamers at home