Spose you can guess what my next little DIY project is ?

[Camel]

Using one of my two remaining 650mm circular saw blades, gunna use a few cut off discs doing these two

[Camel]

Rough cut outs, only used three grinder blades



Reckon I will need a new stone on the bench grinder by the time they are at the handle stage

[Camel]

Oops something is burning

[MISSED]

Great work

Could you fit mine up with a mallee handle and don’t worry about polishing it up to much

[trevort]

You sending them off somewhere for heat treating? Make three and I’ll buy one off ya


Sent from my iPhone using Tapatalk

[Rabbitz]

Using one of my two remaining 650mm circular saw blades, gunna use a few cut off discs doing these two

His neighbour said "He was a quiet sort of bloke, kept to himself mostly, the whole town is shocked and can't believe he'd do such a thing".

Police enquiries are continuing.

[LoneRider]

finger grips in the wood handles make a big difference

[Branxhunter]

Using one of my two remaining 650mm circular saw blades, gunna use a few cut off discs doing these two

Juggling - just getting the equipment sorted?

Marcus

[Camel]

Jeez, some of you fellas have a sense of humour, who would have guessed that.

Those two are already spoken for, will try do some more after new year if there is enough interest and of course $ signs put before my eyes.

Trev, they are hardened steel, no need to heat treat them, I will be only grinding and filing gently so shouldnt stuff up the hardness.

finger grips in the wood handles make a big difference

Yeah they would, the one I traced around is my old one, handle is grippy enough without the grooves.

Will be doing some more tomorrow.

[mick_762]

Looking good mate - should have a nice heft.

[kickinback]

There’s no hole to fit them to the circular saw.


Sent from my iPad using Tapatalk Pro

[The Raven]

There’s no hole to fit them to the circular saw.


Sent from my iPad using Tapatalk Pro

They’ll need the right sized hole to fit my Worx tools


Sent from my iPhone using Tapatalk

[Camel]

Done a bit more this morning

Sanded back the light surface rust with 120 grit paper stuck to a bit of 25x50 steel tube, not going to remove the stain just the rust itself, gives it a nice patina.



Locked up tight in a jig I made to hold knife blades locked when I am using a file.



No heat generated using a mill bastard flat file.



Still magnetic



Piling up the filings, just wish I could get a new decent file around here, hardware only has Indonesian or Indian made shit

[Camel]

Looking good mate - should have a nice heft.

Just weighed it, 1 1/2 to 2 kg

[kickinback]

Looking good mate - should have a nice heft.

Just weighed it, 1 1/2 to 2 kg

That’s not weighing mate, that’s guessing.


Sent from my iPad using Tapatalk Pro