AusVarmint

I've bedded half a dozen centre fires over the years but still to do a rim fire , is there anything to take particular notice of when doing the cz ?

I had trouble with the "blueing" on mine. It had a bit of texture to it and didn't release cleanly. I ended up polishing the action right back to bare metal. There is a post in the gun smithing forum about it.

That's a nice stock on it kickinback, every time I see a Richards micro fit I get the shits that they won't export them anymore

Have done three bedding jobs on 453s, just do the rear tang and the front half inch of action plus first half inch or so of barrel. Pretty simple really. Plenty of release agent. Remove trigger and all the hanging down bits. I don't put the steel block under the action back in after bedding.

Glen, that's the first time Ive seen that thread you linked, you really are a clever little bunny aren't you.

BP72 wrote:That's a nice stock on it kickinback, every time I see a Richards micro fit I get the shits that they won't export them anymore

Yep, shits me to tears as well.

So I should do something wth this 1 then?

Trump card.

DSD wrote:So I should do something wth this 1 then?

No good to me , I'm left handed

Kids toy ?