Bedding a cz453 American

BP72 · Post by **BP72** » Sun May 31, 2015 8:56 pm

I've bedded half a dozen centre fires over the years but still to do a rim fire , is there anything to take particular notice of when doing the cz ?

kickinback · Post by **kickinback** » Sun May 31, 2015 9:19 pm

I had trouble with the "blueing" on mine. It had a bit of texture to it and didn't release cleanly. I ended up polishing the action right back to bare metal. There is a post in the gun smithing forum about it.

kickinback · Post by **kickinback** » Sun May 31, 2015 9:43 pm

http://www.ausvarmint.com/forum/viewtop ... =2&t=12291

BP72 · Post by **BP72** » Sun May 31, 2015 9:59 pm

That's a nice stock on it kickinback, every time I see a Richards micro fit I get the shits that they won't export them anymore

Camel · Post by **Camel** » Sun May 31, 2015 10:02 pm

Have done three bedding jobs on 453s, just do the rear tang and the front half inch of action plus first half inch or so of barrel. Pretty simple really. Plenty of release agent. Remove trigger and all the hanging down bits. I don't put the steel block under the action back in after bedding.

Glen, that's the first time Ive seen that thread you linked, you really are a clever little bunny aren't you.

BP72 wrote:That's a nice stock on it kickinback, every time I see a Richards micro fit I get the shits that they won't export them anymore

Yep, shits me to tears as well.

DSD · Post by **DSD** » Mon Jun 01, 2015 3:25 pm

So I should do something wth this 1 then?

kickinback · Post by **kickinback** » Mon Jun 01, 2015 4:12 pm

Trump card.

BP72 · Post by **BP72** » Mon Jun 01, 2015 5:38 pm

DSD wrote:So I should do something wth this 1 then?

No good to me , I'm left handed

Post by **MISSED** » Mon Jun 01, 2015 7:44 pm

Kids toy ?

AusVarmint