AusVarmint

I am about to order some Forster dies for an upcoming 6x47Lapua build
but the neck die uses bushes not expander. I think I should get at least 3
but not sure what size for the correct neck tension.
The reamer that will be used is a .272 neck, could someone help
I,m told this is a no turn neck, is that also correct?
Thanks in advance

.....267,.268 and .269 works for me.

I am running a 269 bushing on unturned brass in my 6x47L, then after the second firing giving them a light skim and using a 267.

I use a body die and the Forster FLS die as per this article http://bulletin.accurateshooter.com/201 ... 47-to-6mm/

That was quick, thanks Missed much appreciated.
I will probably have lots of 6x47L questions in the near future so
hope you blokes dont get sick of me
Cheers & thanks again

Bring em on. It is a great cartridge.

I use a 266 and a 268 bushing. Love the 6x47L.

Thanks for the replies & links fellas.
I have a gut feeling the old 22/250 might become a safe queen
Cheers

I use a .268 bushing with a no turn neck.

Glenn

Seat a projectile in a couple of cases ,then measure the outside of the neck ,as a ready reckoner........subtract 2 thou from that figure.