![Image](http://uploads.tapatalk-cdn.com/20190625/bae8bdaf66ac79c7714cf66f746b76ee.jpg)
Then got stuck in with the sanding belt to the blade
![Image](http://uploads.tapatalk-cdn.com/20190625/dd2ab6d295b40a4e55096d652182cb82.jpg)
![Image](http://uploads.tapatalk-cdn.com/20190625/febca3c1edff2db0af953900b7a7429a.jpg)
Nah, that isn’t heat coloration just a reflection from the sky light. Found a nice figured piece of Aust red cedar to make the new handle from.
![Image](http://uploads.tapatalk-cdn.com/20190625/d607cfeb7779cde4e2ebad747504815f.jpg)
Traced and cut out the scales, glued and pinned them and left over night for the epoxy to set. Then ground/sanded to final shape
![Image](http://uploads.tapatalk-cdn.com/20190625/b7ca2c76856df604daa92a442d87d670.jpg)
![Image](http://uploads.tapatalk-cdn.com/20190625/618905ef362ce768943addd9a98517fa.jpg)
The name plate was the hardest bit to inlet but it ended up nice and flush with the final sanding. Got a couple of coats of oil and polish on it yesterday and finished it off tod
![Image](http://uploads.tapatalk-cdn.com/20190625/729608c55bde367c664c615beb50682c.jpg)
![Image](http://uploads.tapatalk-cdn.com/20190625/87ebe7b74025c7eeef370fc249a51b5e.jpg)
![Image](http://uploads.tapatalk-cdn.com/20190625/c66344570f8a69ac88777a47ef405cc3.jpg)
![Image](http://uploads.tapatalk-cdn.com/20190625/ff209d16f9e320d790433ddd7fe4377a.jpg)
Sorry about the out of focus photos this stupid phone focused on the chair
![Image](http://emoji.tapatalk-cdn.com/emoji849.png)
![Image](http://emoji.tapatalk-cdn.com/emoji1787.png)
![Image](http://emoji.tapatalk-cdn.com/emoji106.png)