AusVarmint

Sent from my iPad using Tapatalk

Hell !!!!! that would not have been a nice experience

No injuries I hope

Flip

Maybe back it off a grain or two

Seriously scary stuff.

Crikey!

The Raven wrote: ↑Wed Jun 14, 2017 6:37 pm Maybe back it off a grain or two

Nah only minor cratering on the firing pin strike and still a radius on the edge of the primer good to add a few more grains.

.......ouch... DAMN

Quick load suggested about 135,000psi

The trigger puller is fine.

He had the $30 SSAA Insurance and they are paying for the replacement rifle under accidental damage.

That's pretty full on Seddo. It's extraordinary to see both the damage that has occurred to the rifle, but to also hear the shooter was OK.

Marcus

Yikes! That is quite instructive for those considering a sako/m-16 extractor conversion on a Rem 700.

Damn what mess..pretty good reminder to be careful


Sent from my SM-N910G using Tapatalk

Amazing how much damage was done to so many pieces. Is there a part pictured that's reusable?

The Raven wrote: ↑Thu Jun 15, 2017 8:23 am Amazing how much damage was done to so many pieces. Is there a part pictured that's reusable?

The trigger survived, it just needed a clean up. The rest of the parts are scrap.

Seddo wrote: ↑Thu Jun 15, 2017 10:06 am

The Raven wrote: ↑Thu Jun 15, 2017 8:23 am Amazing how much damage was done to so many pieces. Is there a part pictured that's reusable?

The trigger survived, it just needed a clean up. The rest of the parts are scrap.

That mount base might be alright with a little polish. Scope blown off/buggered as well ??

The scope has a small dint from when the pin in the base decided it didn't want to be there anymore.

Blimey!!