AusVarmint

Hi All

Have finally found the dies that I have been looking for
and RCBS make them in G series dies
But does any one know of the best place to order them
here in Aust.
Cheers Brent

NIOA is the imoprter mate so most gunshops should be able to get them in for you. Might take a while though

I can arrange this for you mate.

What cartridge ... might be able to save you money unless you must have RCBS.
Cheers...
Con

Con wrote:What cartridge ... might be able to save you money unless you must have RCBS.
Cheers...
Con

Hi Con

244 REM AI Dies
6.5 257ROBERTS AI Dies
7x57 AI Dies

All x57 mauser based cases
need FS / ST /NK bushing For all
except for the 244REM do not need NK Die

Cheers Brent

Needing the 3 dies makes it harder, but try Redding (Series D) as you'll usually pay less then RCBS ... but get quotes on both.

CH/4D make cheaper die sets than RCBS for kinky stuff by a factor of x2-3 ... heard of someone that recently paid near $500 for an RCBS die set that would have been under $180 direct from CH/4D. Check CH/4D for neck bushing dies ... not sure if they make them ... but easy to deal with direct.

There's also a guy at AHN that goes by the username DavidC that will make you custom neck bushing dies based on 3 fired cases.

Another option is Forster, buy direct after sending 3 fired cases to them to hone the neck to exactly the clearance you require for an added US$10-15.

Cheers...
Con
PS: Just noticed your location ... bit of fun up your way with fires? Hope no damage done, mate was evac'd Sunday and no power to return home. Fires got within a cricket-pitch of the house.

To All

Thanks for all the help, PM's and contacts and I think things will be found now
messages have been sent and it looking good

Cheers to All Brent