AusVarmint

Does anyone on here have a Corbin CSP-1 S-Press. If so how have you found it operation wise?

A Corbin Csp1 press is a bullet swaging press but you can reload on it. Not that great for small cartridges .
As a swaging press it will work very well upto short 458 cal bullets.
They are exaggerating a bit labelling this press as " benchrest reloading "
It's a very good bullet swaging press that also can reload .
You need to state which purpose you want the press for .

I will use it for reloading. Not buying one tho, I will be making it.

kickinback wrote:I will use it for reloading. Not buying one tho, I will be making it.

Unless you are reloading for very large cartrdiges it's overkill for reloading , slow to use and heavy to move about .
You could buy an RCBS RC for what it will cost to build this exact press because of the amount of metal and roller bearing design , heat treating , painting , pluss tooling wear and tear .
However if you want to do it as a project then by all means .

How can it be any slower than any other manual press?

As for material cost, tooling etc, who gives a shit. You don't know me, you don't know what I do for a living or machinery I have at my disposal. If you want to have a crack with an overwhelming opinion keep going, it's giving me a good chuckle.

kickinback wrote:How can it be any slower than any other manual press?

As for material cost, tooling etc, who gives a shit. You don't know me, you don't know what I do for a living or machinery I have at my disposal. If you want to have a crack with an overwhelming opinion keep going, it's giving me a good chuckle.

If you knew what you were doing you would not be smashing up your press .
No one is having a go at you mate . Trying to work out if the press will suite what you want , but hey srew you sport your just a nasty little prick with a big mouth . I have all the Corbin plans to this exact press and I was initially thinking I could send them to you if you were set on making one but now you can F*ck off .

No wonder you have been savaged on other forums Unhappy Jack

You're a bit of a knowitall eh Jack. I don't need plans fella. 1 photo is pretty much all it takes. I will make it with enough variation from the original in resoect for Corbins time and effort. As for smashing my press, so what. I don't pissant around. If I have something to do, I get it done.

I personally believe you should just come out openly and tell everyone that you know everything. It will save some of us from wasting our time.

Thanks for showing your true colors.

Lots of love

Glen

Oh BTW, read the initial post and comment on that, not what google told you.