Page 3 of 3
Re: What went wrong?
Posted: Wed Mar 23, 2011 8:18 pm
by m12vlp
kurcha wrote:from the photo neck tension hmm high did u use epander ball or not?
how can you tell neck tension from fired cases
Anyway I used a sinclair 25cal expander die. I don't pull buttons through necks
Re: What went wrong?
Posted: Wed Mar 23, 2011 10:46 pm
by Sam Walker
It looks as if the neck is bulging where the bullet is - like it's been sized down a bit too much ? I've ever seen that in any of my ammo..
Re: What went wrong?
Posted: Thu Mar 24, 2011 5:16 am
by m12vlp
Sam Walker wrote:It looks as if the neck is bulging where the bullet is - like it's been sized down a bit too much ? I've ever seen that in any of my ammo..
Which pictures are we looking at?
My fired cases? or the examples of neck weld?
Re: What went wrong?
Posted: Sun May 01, 2011 4:11 pm
by kurcha
loaded rounds,also I see some bright lines on them vertical see them? I dont use expander ball too that way have better groups ,bullets jaming in the lands? makes big difference, high neck tension changes rate of detonation ,storing ammo in high flactuating tem ,powder goes off.
Fine scrathes on cases with hot loads dont help too check u dies and chamber