Primer catcher for an RCBS Rockchucker Supreme

[Cammo]

EBay have 3D printed primer catchers for the Rockchucker Supreme to replace the inverted Y catcher. The catcher is enclosed and the spent primer goes down a hose into a bottle.

From USA they cost around $50 AUD plus $45 AUD postage, does anyone in Australia print them? I'd prefer to keep my $ here if possible and the postage is ridiculous.

regards

[trevort]

I like the sound of spent
primers rattling around in the dyson


Sent from my iPhone using Tapatalk

[The Raven]

I like the sound of spent
primers rattling around in the dyson


Sent from my iPhone using Tapatalk

Add some excitement, try live primers.

One of my first jobs was at a car wash with and industrial multi-hose vacuum. Amazing how many loose rounds we collected.

A bit scary when you see half a dozen loose rim fire vanish up the nozzle to rattle through 10-15 metres of steel pipe before dropping into the steel drum.

Upside was that loose coins funded our Christmas party.


Sent from my iPhone using Tapatalk

[bimbo]

I have a file for one somewhere, I'll dig it out and print a couple for you to try if you want

[The Raven]

I have a file for one somewhere, I'll dig it out and print a couple for you to try if you want

If it's not too much of an ask, would you be able to make the following? If so, let me know a price as I suspect the die storage tray may use a fair bit of material.

https://www.thingiverse.com/thing:2850028

Three of the above.

https://www.thingiverse.com/thing:1972400

Just one of the ram arm.

[Rabbitz]

I always thought that the floor did an acceptable job of catching them.

I can't remember one missing the floor - although I do remember standing on one or two in bare feet...

[The Raven]

I always thought that the floor did an acceptable job of catching them.

I can't remember one missing the floor - although I do remember standing on one or two in bare feet...

That last bit is what hurts, followed by Mrs Raven complaining when they go up the vac....

[Cammo]

bimbo
That'd be great and I'm happy to pay for the privilege.
Until then 'll have to stop wearing Crocs when reloading as the dropped primers play havoc when you walk.

[B4408]

I have a file for one somewhere, I'll dig it out and print a couple for you to try if you want

If it's not too much of an ask, would you be able to make the following? If so, let me know a price as I suspect the die storage tray may use a fair bit of material.

https://www.thingiverse.com/thing:2850028

Three of the above.

https://www.thingiverse.com/thing:1972400

Just one of the ram arm.

Like these

Lee ram infill

better PM me your address.
Bruce

[B4408]

Cammo
I can print something but would need the design.
See how you go from the other guys and get in touch if you have no luck.

Bruce

[The Raven]

Like these
20200506_171940a.jpg
better PM me your address.
Bruce

Thankyou

[Cammo]

Got one as I found some online is Aus, very good.