Faith restoration in the younger generation

[curan]

Nah, you have to say worse stuff than that to get banned on FB.

Well that just confirms my unconscious and conscious biases against facebook.

+1

[MISSED]

Knackers is forever in the FB sin bin

[The Raven]

The ADI manual is available online as well.

Happy loading.

Marcus

I like the ADI manual as it always provides the most up to date information.

[bimbo]

ADI is the go to for me too as I use their powders but also like to double check against another manual when starting a new loaf just to double check they are suggesting similar loads

[The Raven]

ADI is the go to for me too as I use their powders but also like to double check against another manual when starting a new loaf just to double check they are suggesting similar loads

Yeah, I do that to. It's definitely a good idea as you never know when a typo or internet glitch could transpose a digit or two.

[DSD]

I might get the van stick. Some fucken wanker asked why trim cases over listed max length when they still chamber

I. Replied

Why would you set off little home made explosives beside your face without reading an instruction manual ffs


Sent from my iPhone using Tapatalk

I would guess that was a loaded question and old m8 is at home laughing because he actually knows the answer to what happens next

Ps it's not your rifle blowing up!

Sent from my SM-G930F using Tapatalk

[Stuie0]

And today I finally put all the reading into action.

As well as the old tip press, which is not very accurate at all hahaha
But with careful consideration and measuring every round, I've produced some that will hopefully fire out the end of my rifle.

Hopefully my new press comes this week as well as a few other small things to make the process easier.

Sent from my SM-G960F using Tapatalk

[trevort]

Buy a decapping die and use the tip press for decapping


Sent from my iPhone using Tapatalk

[The Raven]

Buy a decapping die and use the tip press for decapping


Sent from my iPhone using Tapatalk

If I had the bench space that's exactly what I was planning to do with it. In any case, I prefer to decap and clean then resize. So a decapper is good for that.

[Stuie0]

Buy a decapping die and use the tip press for decapping


Sent from my iPhone using Tapatalk

That's what I'll be doing

Sent from my SM-G960F using Tapatalk

[Camel]

And today I finally put all the reading into action.

As well as the old tip press, which is not very accurate at all hahaha
But with careful consideration and measuring every round, I've produced some that will hopefully fire out the end of my rifle.

Hopefully my new press comes this week as well as a few other small things to make the process easier.

Sent from my SM-G960F using Tapatalk

Good to see the tip press getting a work out