My new rifle in semi finished stock as received just before Christmas. Build details: Rem700 action trued by Peter Van Muers, Timney trigger, fluted MADDCO barrel (26" modified No5 profile), PTG Steallth Obendorf DBM, Tasco Japan target scope, A3 style stock by Ken Noye with anschutz fore-rail and a Whidden V-block. All gunplumbing and cerakoting by Luke Easter of ProCal trading. Everything came together just as I wanted, I do think I should have chosen a slightly lighter profile barrel, the only headache encountered was in my gunsmith dealing with PTG - for the DBM
My first sighting target for this rifle. Breaking in the new MADDCO barrel with Hornady factory ammunition at 100m. Barrel was cleaned, (scope bore sighted and aligned by eye on a 500m gong) fired the first 2 sighting rounds (POI 6" low), cleaned and adjusted sights This is the first 5 round group fired in this barrel - promising. The flyer at low left was shooters error. 1" squares on this target.
Sighting in at 100m, Cold Bore, Clean Bore, with untested handloads. Shooting from the bench on a bipod and rear bag - I could use a benchrest type front rest and bag, but prefer to test it the way I intend to use it. My worst groups for the day were just under MOA including called flyers, average was probably 0.6"-0.7" Including my own errors. 1/2" squares on this target
Load development target fired yesterday, Range 100m, grids are 1/2" squares (Both groups were using 27.5gr of 8208 behind a 39gr Sierra Blitzking King, Rem 7.5 primers). NOTE published max load 27.3gr)
Load development target fired yesterday, Range 100m, grids are 1/2" squares (Left Group: 26.7gr of 8208 behind a 39gr Sierra Blitzking King, Rem 7.5 primers Right Group: 27.0gr of 8208 behind a 39gr Sierra Blitzking King, Rem 7.5 primers).
