17 hmr

[als008]

Im not sure if the CZ are supposed to be floated from factory. I tried to slide a piece of paper between the barrel and fore end and had no luck. Left side is clear and the back end(about 10" fwd of the action) is all clear. Just has some light contact at the fwd rhs of the fore end. Im thinking of pulling the barreled action out and giving the stock some light clearancing with sandpaper to float the barrel the whole way.

[GIJ]

Im not sure if the CZ are supposed to be floated from factory. I tried to slide a piece of paper between the barrel and fore end and had no luck. Left side is clear and the back end(about 10" fwd of the action) is all clear. Just has some light contact at the fwd rhs of the fore end. Im thinking of pulling the barreled action out and giving the stock some light clearancing with sandpaper to float the barrel the whole way.

Yeah, I think I was just lucky with mine. I can slide a piece of paper right up to the action. My Tikka touched the same way as your cz so I took the stock off and had a go with some sand paper and its all good now.

[MISSED]

my Annie is fully floated with an adjustable trigger(I know this because I drool over it everytime I go to my LGS) while I wait for my PTA which should be a PITA Applied 16/11 approved 28/11 still waiting lost in the post ,Now have to apply for a replacement copy which will take 7 to 10 days from the reciept of my new application.Fark am I over this.
OK end of rant and no I don`t feel any better

[Knackers]

will take 7 to 10 days from the reciept of my new application.Fark am I over this.

wouldn't that cock ya god damn pistol, I thought that sorta shit only happened to me.
You should beable to print one off online after your ID checks out FFS, wouldn't that make things easier for everyone?

Must admit that when I saw that you posted on the main index I got all excited thinking that you picked up your new rifle