AusVarmint

Hello all,

I went looking on the net for printable targets for sghting in and practicing smallbore at 50m.

I wanted something with 6 targets, and not too busy on an A4 sheet. Couldn't find what I was after, and then realised I could probably make my own with the draw function on MS Word.

So I did. It wasn't that hard to put a 1" circle in a 2" square, and then give it a few reference points. And if you have your "page setup" set to A4 paper, it prints to size, so it's all good.

And then I figured I should share.
I hope the attachments work.......haven't done it before, but hopefully I got it right.

regards, curan

Thanks for sharing Curan, they will come in handy.

Try this one,it fits on A4

Steve

Hey Guys here is one that i 'stole' from a fellow member.
Using Excel you can add load data etc on the targets.